storageer.blogg.se - Different partitions same hard drive crystal disk mark

The program will do it itself and will signal the state of each parameter with a color indicator, the decoding of the values of which will be the same as in the previous paragraph. Again, let me remind you that you do not need to know the specific values of the parameters at all. This is where data on the main parameters are displayed on the basis of which CrystallDiskInfo makes a conclusion about the state of the hard disk.

And finally, the largest part of the main window marked with a number 4.

Accordingly, red indicates a bad state of the hard disk, and gray indicates that the program cannot determine the parameters of the device. Yellow color will mean a warning that some of the parameters is close to critical, which may soon lead to damage and data loss. As you can see, the blue color means that your screw is in good condition. In fact, this program itself evaluates the values of all monitored parameters and issues a conclusion about the general condition of the device and its temperature. Two indicators are marked that show the general status of the hard drive. In principle, the longevity of the hard disk does not depend on these parameters rather, they are provided for informational purposes. The main characteristics of the hard disk are marked: manufacturer, full model name, volume, total operating time and much more. If there are several, all of them will be displayed on this panel, it is through it that you can switch between the available devices, accordingly all the information provided below will change. As you can see, in this example, I only have one disk. There is a panel that displays all the disks that the program has found in your system. Let's return now to the main window of the program.

Now CrystallDiskInfo added, and also its two icons appeared in the tray, one of which shows the current temperature of the hard disk. So you need to go to the menu "Service" and include items and "Launching the agent (in the notification area)". The main idea of the program is to constantly monitor the operation of the hard disk, but for some reason the authors did not include autorun from the start of the operating system in the initial setting. Having launched this miracle of programming thought, you can make sure that it has an easy interface and most of the information can be obtained immediately from the main window.īefore we start describing everything we saw, let's do a little preliminary setup.

Today I will introduce you to a program that is constantly monitoring the condition, and it is called CrystalDiskInfo. Once again, I am glad to welcome everyone to the pages of this project. Hello dear readers, visitors and other personalities.